Rocker Switch 15 Amp
Call Only
This is the on/off switch, located on both the waste oil burner and fuel pump assembly.
Round Face Gauge (old style)
Call Only
Located on the front of the electrical box on the burner housing. Used on older model heaters and can be used as a replacement for the square face gauge if needed. New models standard build is with the square face gauge.
Snap Switch (New Style)
Call Only
This new style snap switch screws on to the fuel pre-heater block with two little screws. Located on the fuel pre-heater block assembly.
Snap Switch (Old Style)
Call Only
The old style snap switch screws into the side of the fuel pre-heater block. Located on the fuel pre-heater block assembly.
Spin On Filter Assembly (New Style)
Call Only
All new units purchased come standard with this spin-on fuel filter and housing. This housing and spin-on fuel filter can also be used to convert your old style from the pancake serviceable fuel filter to the new style spin-on fuel filter.
Spin On Filter Replacement (New Style)
Call Only
Spin-On fuel filter replacement (filter only), located on the fuel pump assembly.
Square Face Gauge
Call Only
Located in the front of the electrical box on the waste oil burner assembly.
Straight Fitting
Call Only
This fitting is used in multiple locations as follows: (2) Attached to the back side of the square faced air gauge on the waste oil burner electrical box. (1) Attached to the fuel pre-heater block
Suntec Fuel Pump
Call Only
The Suntec fuel pump is located on the outside of the fuel pump assembly housing.
Suntec Gasket
Call Only
This gasket is located inside of the Suntec fuel pump on the outside of the fuel pump assembly.