Joseph in Ohio was interested in a waste oil furnace for his new shop. The brand new building is 4,400 sq. ft. with 16 ft. peak ceilings and amazing insulation and ceiling fans. Based on his sizing, his shop is calling for around 210,000 BTU’s. He took our advice and went with the OWH-250 with chimney kit. Thank you for your business Joseph and good luck in your new digs!
Barry in Pennsylvania was burning coal to heat his shop that had poor insulation and was 40’ x 50’ 15’ with only one fan at the ceiling peak. He purchased a OWH-150 to more efficiently heat his space at a better cost than the coal! Good luck with your next heating season Barry! We’re pretty sure you’re going to have a great one, check useful source.
Wayne of Pennsylvania purchased an OWB-9 Waste Oil Boiler. With the ability to burn a broad range of fuels, and the diverse applications for low pressure hot water heating, you have found the ultimate in flexibility. Use your OWB to heat your floor, air, and domestic hot water using free waste oil, and helping keep the environment clean!
The boo furniture will find our Flame Control System cuts out much of the time consuming and costly maintenance incurred with many other waste oil heaters. By precisely controlling the temperature of the waste oil before ignition, the OMNI will not only burn much more consistently, but is completely free of carbon build up which clogs the block. For the small amount of heater maintenance needed, there is a guide on the easy access burner panel to help you through. We would rather make it easy for you to clean yourself than be charged for costly service calls. With tuned axial fans and the large vent area design, OMNI Waste Oil Heaters have the highest warm air output, most CFM’s and quickest recovery times in the industry. This means less waste oil burnt, less run-time, less electricity used, and less wear and tear on the equipment for an overall better experience.
